![]() ![]() The third & final generation of the CR250 aluminum chassis also made its appearance, which was thinner, with better flex properties. The ECM would now be able to retard ignition timing to preclude preignition, though there was no ping sensor anywhere. A TPS (Throttle Position Sensor) was added to the carburetor, powered by a new stator. The new Mikuni TMX carburetor proved to be temperamental to weather changes.įor 2002, Honda ended the outstanding interchangeability that had existed from 1992~2001, whenĪ completely new engine arrived with a change from cylinder reed induction to an engine case reed induction system and an electronically controlled, cable operated RC valve in place of the centrifugally operated exhaust valve system used since 1992. The 2001 model was nearly identical, with a change to a different CDI box, adding 500 RPM to the redline where two more horsepower lurked. The Keihin PWK carburetor replaced earlier PJ models. The 1999 model was almost identical but the Power Jet had disappeared.įor 2000, the 'second gen' aluminum frame was less rigid, with thinner twin-spars, providing a rigidity decrease and better handling. Included in the new electrics was a capacitor and a rectifier/regulator. The 1997-8 engines were equipped with a new stator, which supplied DC voltage for the new Keihin carburetor with an electronic 'Power Jet' system, in efforts to control lean mixture preignition. These 'first gen' frames were thick, rigid, and were a big change from the previous steel frames, where flexibility had been seen as a problem in the early years. In 1997, Honda produced an industry first, an aluminum chassis for a motocross motorcycle. The CR250 was produced for nearly 37 years, 2007 being the final year of production. The prototype was built in 1971, but it was not until late 1972 that production of the 1973 model "out of the box racers" began sale to the general public. The Honda CR250R was a Honda racing dirt bike. Rear: Showa, adjustable low speed and high speed compression and low speed and high speed reboundĢ40 mm (9.4 in) single disc, front and rear Of course it is all relevent to the size of tires and your ride height as the will effect your rake.249 cc (15.2 cu in) liquid cooled two-stroke singleĥ- speed constant mesh, chain drive, manualįront: Showa, adjustable compression and rebound The 85 ATC 250R has 21* of rake, the 86 ATC 250R has 21.5* of rake. There is a formula for mixing fork oil weights that I too can dig out and post if needed. ![]() If you just want to do progressive suspension springs, I recomend 15 wt fork oil at 5.5 inches from the topĪlso, someone said they mixed oil at 50/50 ratio to get a middle weight. The emulators also come with two springs.blue (installed) and yellow. I have the part numbers for the right emulators and springs somewhere and can post them if needed. ATVonDemand had Race Tech do the mods in there ATC 250R build and went with the. 47kg but they will most likely be to soft. I have been working with the emulators for some time (long before Race Tech even knew about using them in the ATC 250R.heck I even helped them with the set up.lol) and have found that the best springs for the ATC 250R are the. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |